Skip to content

Customize using Mac

Overview

This page is only relevant when building with a Mac.

For Building with a Browser, please see: Customize using Browser

For new Loopers, please build the code before you make any changes. Start with Open Loop and familiarize yourself with the interface. Later, you can make the customization(s) you desire and build again. The second build will be much easier than your first build.

These customizations require you to modify the code used to build the Loop app and then build the app again with the modified code.

You take responsibility

You are responsible when you decide to use customizations.

Be sure to report what changes you made if you need to ask for assistance with your app.

Customizations Prepared for You

Some customizations are the same for everyone and have been prepared for easy use.

The Loop and Learn team is committed to maintaining these prepared customizations and provides an easy method to add your selection from these customizations to your version of Loop.

Please read the documentation for these on the Loop and Learn: Customization Select Page:

Personal Customizations

Some customizations must be created for yourself. These are of two basic types: Custom Edits and Build-Time Flag.

The information needed to modify the code to make these customizations is found in the Versions tab because the information is independent of build method (think of these as your personal versions). The links are found below.

  • Version: Custom Edits
    • The page linked above indicates how you can modify behavior by editing the code
  • Version: Build-Time Flag
    • By enabling or disabling features controlled by a Build-Time Flag, you are turning on or off features included in the code by the developers that they configured to be off or on by default
    • Please read about these flags on the page linked above

When preparing these personal edits using a Mac, there is a page explaining how to open Xcode to the correct folder (where code is stored on your Mac) and incorporate those changes into your personal copy of LoopWorkspace on your Mac before building.

The code changes required for these customizations are the same regardless of the build method. The pages that provide the documentation on modifying and incorporating these changes are found at the links above.